DLTK's Holiday Crafts for Kids
Christmas Pinwheel Craft
© by Leanne Guenther
I loved pinwheels when I was little... They seem to be one of those toys that have been around forever. There are two different templates to pick from.
You can use the templates I've provided or design your own using:
- construction paper and stickers
- fun foam, or
- thin pieces of plastic (like one would use for overhead projectors)
Fun foam ones are nice and sturdy, but you'll need to use straight pins instead of push pins to make them.
- something to color with
- pencil with eraser at the end (unsharpened is best, I think)
- push pin or straight pin
- optional: a small bead (like a pony bead)
- optional: red acrylic paint and paintbrush
- Optional: Paint the pencil red using the acrylic paint
because it dries quickly. You may need to give it a couple of
coats to cover.
- Fold on the dashed line to make a square decorated on both sides.
- Note: At this point, you can put a piece of thin cardboard or construction paper between the two halves
to make your pinwheel a bit sturdier.
- glue the sides so you have a square decorated on both sides.
- Cut on the diagonal dotted lines (don't cut all the way into the middle.
- Bend each corner to the center dot, but don't crease your folds.
- Push a pin through the center into the eraser of a pencil (don't push it
- Optional: put a bead in between the eraser and the paper ... Some
people find it spins a bit better this way... I've never noticed the
difference (maybe it's the type of pencil eraser? I use fresh,
unsharpened school pencils).
- Blow the edge of your pinwheel to make it spin (if it doesn't spin, loosen
your pin a little or wiggle it around to make the hole in the paper bigger).
- Close template window when done printing to return to this screen.
- Set page margins to zero if you have trouble fitting the template on one page (FILE, PAGE SETUP or FILE, PRINTER SETUP in most browsers).
Santa & Rudolf Template
Printable version of these instructions